Instrumente - Seite 3

The HT200B compact clamp meter provides precise measurement of various parameters. It is equipped with a backlit HD display and jaws, which size is up to 18mm. Despite its small size it impresses with functionality. For its power supply it requires 2 AAA 1.5V batteries, which must be purchased separately - they are not included in the set.

Schwarze 200cm Qualitäts-Prüfleitungen mit festem Stecker, doppelt isoliertem hochflexiblem Silikon, 0,75 mm2 12A mit isolierten stapelbaren 4 mm Sicherheits-Bananenstecker. Technische Daten: IEC 61010: CAT III 1000V, CAT IV 600V

Digital Clamp Meter Habotest HT206D True RMS , NCV, LPF

Habotest HT107D Steckdosentester Kontakt

The Habotest HT66 compact gas leak detector detects many different types of flammable gases and ensures safety at home, in the office or during industrial work. It has a high-quality sensor and is extremely precise - its accuracy is ≤10% FS and sensitivity is <50 PPM. It also has the advantage of a response time of about 5 seconds, as well as a visual and audible alarm.

The FNIRSI DSO-TC4 is a portable 3-in-1 instrument combining a digital oscilloscope, electronic component tester and signal generator in a compact handheld design. It is intended for electronics diagnostics, service work and educational use, where multiple measurement functions are required in a single device. The oscilloscope supports a 10 MHz bandwidth with a 48 MSa/s sampling rate, enabling real-time waveform analysis with sufficient detail for general signal inspection. The integrated signal generator provides 13 predefined waveforms with frequency output up to 50 kHz and adjustable amplitude, allowing simulation of circuit behaviour. The component tester automatically identifies and evaluates diodes, transistors, MOSFETs, resistors and capacitors for rapid fault detection. A 2.8-inch TFT display ensures clear visualization of results, while the 1500 mAh rechargeable battery with USB-C charging supports extended portable operation.

Always on for faster, safer voltage testing2AC is the latest addition to the VoltAlertTM ac non- contact voltage tester family from Fluke and is designed to be pocket-sized and easy to use. The 2AC tests for energized circuits and defective grounds, whether it’s for an electrician on the factory floor or the do-it-yourselfer around the house. The tip of the pocket-sized tester will glow red when within close proximity of an outlet, terminal strip, or power cord where voltage is present.Voltage detection from 200 to 1000 V ac, suitable for a wide range of residential, commercial and industrial needs.NEW! Always on, using special low power circuitry to sustain battery life and ensure your 2AC is always ready.NEW! Innovative ‘Battery Check’ button function ensures battery is in good condition*Category IV – 1000 V overvoltage rated product for best in class user protectionIntegrated clip design, optimized for pocket storagePowered by 2x AAA batteries (included)Fluke ruggedness and reliability

The Digital Insulation Resistance Meter is a specialized tool that will come in handy in many situations and will test the ground resistance of power and distribution cables or various types of electrical equipment. The measuring range of earth resistance is from 0Ω to 4.00kΩ. It provides efficient operation through bi-pole or tri-pole mode. Moreover, it has a large and clear LCD display that allows you to read the information obtained efficiently.

Kyoritsu 1030 penmultimeter Produkt beskrivelse: Kyoritsu 1030 er et pen-multimeter, udformet så det kan betjenes med en hånd. Instrumentet måler AC/D...

Habotest HT601A Gaslecksucher Ultraschall-Lecksucher

FNIRSI Handheld Digital Oscilloscope Transistor Tester SigGen 3 in 1 DSO-TC3

The EEx approved Magnet Stick is an instrument for testing for the presence of magneticfields. By simply holding the tip of the instrument near the test area, it indicates a magneticfield by glowing. The test lamp responds to all kinds of magnetic fields, from alternating currentto direct current and permanent magnets. (Sensitivity 300 gauss 0,3 mT). The ATEXand IECEx approvals are confirmed by NEMKO. (II 2G EEx ib IIC T4).APPLICATIONS:– Testing operating solenoid valves in pneumatic and hydraulic control equipment– Testing relays with coils and electrically-controlled solenoid valves in all types of vehiclesand machines– Testing solenoid valves when servicing oil burners

Blau 200cm Qualitätsprüfleitungen mit festem Kapuzenmantel, doppelt isoliertem hochflexiblem Silikon, 0,75 mm2 12A mit isolierten stapelbaren 4 mm Sicherheits-Bananenstecker. Technische Daten: IEC 61010: CAT III 1000V, CAT IV 600V

4 mm, vollständig isoliert, handliches Format, für 4 mm Bananenstecker. Technische Daten: IEC 61010: 33V AC / 70V DC

Better than a test probe alone – these two inch long rigid back probe pins easily pass between the weather pack seal and wire. A sharp point ensures good contact to the electrical connector, and the pin’s insulation protects it from shorting to other wires.Slides onto test probes measuring 2 mm (0.08 inches)Tested to 60 V DC

5,7064454803e+12

The HT61 gas meter detects many types of gases, and thanks to its high-end sensor, provides precise measurement. The device is equipped with a dual alarm - visual and audible. Compact, handy and portable - will prove useful in many applications. To power the meter 2 AAA batteries are required - not included and must be purchased separately.

The FNIRSI SG-004A is a compact mini signal generator offering professional functionality in a pocket-sized design. It features a 2.4-inch HD backlit display, adjustable brightness, real-time curve viewing, and multi-mode operation. With ≤0.2% measurement accuracy, drop protection, USB-C charging, and up to 24 hours standby, it is ideal for field engineers, technicians, and electronics enthusiasts. The device supports a wide range of signal types and testing tasks, including voltage/current testing, speed simulation, actuator adjustment, and inverter diagnostics, providing reliable and portable performance wherever you need it.

Kimo VT110 Heißdraht-Anemometer, inklusive Hartschalenkoffer und Kalibrierungszertifikat.

Kyoritsu K3132 is a safe small and handy insulation tester, whick complies against even the toughest demands. The instrumentet has following advantages and functions: - Chooseable test voltage 250, 500 og 1000 V - Lockable test not – Then you can have both hands free - Mirror display scale – For safe reading - Built in ohm meter for measuring on earth conenctions - Built in voltage meter 0-600V - Exstra safe and robust – Dust and splashproof IP 54, complies with IEC 61010-1 CAT III K3132 is delivered incl. batteries, test leads and manual. Technical data: Test voltage: 250, 500 og 1000V user choseable Measuring ranges: 0-100, 0-200, 0-400 M Measuring current: > 1mA Ohm meter: 0-3 / 0-500 Measuring current/voltage: > 200 mA / 4 V Voltage meter: 0-600 V AC Battery: 6x1,5V LR06 (inkl.) Size: 106x160x72 mm Weight: 560 g

The SparOmeter is a energy meter which can be connected directly in the socket, and will nice and easy show the energy on all 230V appliances up to 2300W/10A. The meter has a lot of features: V, A,W, min.W, max.W, kWh and running time. The SparOmeteret can be set to a measuting period on 1, 7, 30 days or continuesly, the meter will remember the values when disconnected. Technical data: Voltage: 230V AC Current: 10A AC Power: 2300W Accuracy: Class 2 Size: 138x69x75 mm Weight: 180 g

Elma 2700X spændingstester med åben strømtang Produkt beskrivelse: Med Elma 2700X genopfinder Elma spændingstesteren, endnu engang. Elma 2700X har all...

HT126A is a smart and rugged multimeter from Habotest. It is distinguished by its precision measurement, you can also use it outdoors. Equipped with a large display and silicone buttons - it is simple and comfortable to use. Compact and lightweight - it also has a LED flashlight, which allows you to work even in dark places. It requires 4 AAA 1.5V batteries to power it. However, these are not included and must be purchased separately. You can use it to measure voltage, resistance, capacitance, etc.

The Habotest HT607 meter can measure humidity, ambient temperature, dew point and wet thermometer. It will therefore prove useful in places such as a laboratory or warehouse. It is equipped with an LCD screen that displays measurement results in real time. It is distinguished by its fast response time and shuts down automatically after a certain period of time to save energy.

Elma EVSE-200 type 2 adapter Produkt beskrivelse: Elma EVSE-200 adapter aktiverer ladestander, ved at simulere tilslutning af elbil, og bringer målepu...