Danfoss AMV 150 actuator. AMV 150 is an actuator for three point control for use in district heating systems. The actuator is available for the Danfoss ECL Comfort controllers or any other three point controls.

Danfoss RAVK Thermostatic actuator. Self-acting thermostatic actuator primarily used for temperature control of small hot water cylinders (e.g. storage tanks) or heat exchangers in radiator heating systems. Combined with RAV it is intended for temperatu

Danfoss KP thermostats are used for regulating, monitoring and alarm systems in industry. The KP series are temperature-operated electric circuit breakers. The thermostats are fitted with a single-pole switch (SPDT), and can control single-phase ac motors

Platinum-based sensors, 1000 at 0 °C.All the temperature sensors are two-wire devices, and all connections are inter-changeable.The surface sensor type ESM-11 has a spring contact surface to ensure a good heat transfer on pipes of all sizes.The basic sensor contains a platinum elementwith a characteristic that complies with EN 60751.

Demanding applications, with IP65, for valve range B, 10W ac / 18W dc

Danfoss AMV 435 actuator. AMV 435 is an actuator for three point control and AME 435 is an actuator for modulating control. The advanced design incorporates load related 'switch-off' to ensure that neither actuators nor valves are not exposed to overloa

Danfoss AVTB thermostatic water valves. Self-acting temperature controller used to control the water temperature in hot water tanks, heat exchangers, oil preheaters, etc. The controller has a control valve, thermostatic actuator and handle for temperature

Danfoss ABV NC thermal actuator. ABV is a thermo hydraulic motor for two point control, which can be used with small seated valves to control floor temperature, floor heating systems, hot-water service systems, zone valves and district heating systems.

Danfoss ECL Comfort 210 regulator 230V. The ECL Comfort 210 is an electronic weather compensated temperature controller for use in district heating, central heating and cooling systems. Combined with the intelligent ECL application keys, the controller

Danfoss AVTB thermostatic water valves. Self-acting temperature controller used to control the water temperature in hot water tanks, heat exchangers, oil preheaters, etc. The controller has a control valve, thermostatic actuator and handle for temperature

Danfoss AVTA thermostatic water valves. AVTA thermostatic operated water valves are widely used for temperature control in many different sorts of equipment and installations where cooling is required.

Danfoss RAVI Thermostatic actuator. Self-acting thermostatic actuator primarily used for temperature control of small hot water cylinders - either storage type cylinders or instantaneous hot water heaters. The controller closes on rising temperature.

TPOne-M, mains powered electronic programmable room thermostat.

RAVK is self-acting thermostatic actuator primarily for use for temperature control of small hot water cylinders (e.g. storage tanks) or heat exchangers in radiator heating systems. Can be used with RAV/KOVM/VMT valves

CS pressure switches have a three-pole switch and adjustable differential. The pressure switches are fitted with a manual switch that will lock the contact system in the open position independently of the pressure in the system.

Danfoss ECL Comfort 310 regulator 230V. The ECL Comfort 310 is an electronic weather compensated temperature controller for use in district heating, central heating and cooling systems. Combined with the intelligent ECL application keys, the controller

Permanent Magnetic coil 018F0091 from DANFOSS A/S

Insulation rings for AVTB

Self-acting thermostatic actuator primarily used for temperature control of small hot water cylinders (e.g. storage tanks) or heat exchangers in radiator heating systems. Combined with RAV it is intended for temperature control in a mixing loop for hot water service. The controller closes on rising temperature.

Pressure switch 060-110166 from DANFOSS A/S

Danfoss ECL Comfort A266 application key. Weather compensated flow temperature control of heating systems with sliding return temperature limitation. Constant temperature control of DHW circuits with flow system. Additional functions: flow switch contro

EV220B 15-50 is a universal indirect servo-operated 2/2-way solenoid valve program. Valve body in brass, dezincification resistant brass and stainless steel ensures that a broad variety of application can be covered. Built-in pilot filter as standard, adj

Danfoss KP thermostats are used for regulating, monitoring and alarm systems in industry. The KP series are temperature-operated electric circuit breakers. The thermostats are fitted with a single-pole switch (SPDT), and can control single-phase ac motors

Danfoss AMV 10 actuator. AMV 10/13 are actuators for three point control and AME 10/13 are actuators for modulating control, furthermore AMV(E) 13 actuators have safety function. The spring return actuators can be used to provide safety shut off on power

Danfoss AVP differential pressure controller. Self-acting differential pressure controller primarily for use in district heating systems. The controller closes on rising differential pressure. The controller has a control valve, an actuator with one cont